Numerical Analysis of Thermal Cracking Estimation of Mass Concrete With Ggbs at an Early Age

Document Type : Original Article

Authors

1 Environmental Sciences and Industrial Development Department, Faculty of Postgraduate Studies for Advanced Sciences (PSAS), Beni-Suef University, Beni-Suef 62511, Egypt

2 Civil Engineering Department, Faculty of Engineering, Beni-Suef University, Beni-Suef 62511, Egypt.

3 Central Metallurgical Research and Development Institute (CMRDI), Helwan, Cairo 11421, Egypt.

Abstract

At an early age, the temperature rise in mass concrete is attributable primarily to the propagation of heat due to an exothermic reaction of cementitious materials and water. The temperature variation in the mass concrete between the core and its surfaces results in the development of thermal stresses. It might occur cracking if these stresses surpass the gained tensile strength of concrete. The paper compares experimental and numerical outcomes of heat generation in concrete mould 0.15 m × 0.15 m × 0.15 m in size. Four concrete mixtures with ground granulated blast-furnace slag (GGBS) replacement to cement 0%, 10%, 30%, and 50% were used in the study. Virtual Cement and Concrete Testing Laboratory (VCCTL) software was used for obtaining the degree of hydration and adiabatic temperature of the four mixtures. Finite element modeling of these mixtures observed good agreement with experimental testing captured by the thermometer. Following that, numerical simulation was utilized to study the effect of the block size (cubic models with edge length 0.5 m, 1.0 m, 2.0 m, and 3.0 m) on temperature rise and the associated risk of cracking in mass concrete blocks.

Keywords

Main Subjects

Files

Cited by

History

  • Receive Date: 23 September 2021
  • Revise Date: 13 November 2021
  • Accept Date: 18 November 2021

Share

How to cite

Statistics